Casa Lambretta
Control rod (splined type): Series 1-2
The splined rods that fit inside your handlebars have long been a problem during resto’s and the onl..
$21.00
Control rod (splined type): Series 3 Li
The splined rods that fit inside your handlebars have long been a problem during resto’s and the onl..
$21.00
Control rod (splined type): Series 3 LiS/TV
The splined rods that fit inside your handlebars have long been a problem during resto’s and the onl..
$21.00
Control rod: all from 1966
This is a handlebar control rod for late Series 3 Li/LiS/SX and all DL/GP scooters, ones that use ..
$12.00
Control rod: Indian GP
This is a handlebar control rod is made to fit Indian SIL GP scooters but can also be made to fit la..
$12.00
Crankcase and gearbox dowel pin
These dowel pins fit in your engine case and are used to locate the crankcase side. They are also ..
$1.00
Crankcase side cover engine oil level plug
Standard drain plug for all Series 1-3, DL/GP Lambretta. Made in Italy.Gasket sold seperate...
$10.00
Crankcase side cover engine oil magnetic drain plug
Standard magnetic drain plug for all Series 1-3, DL/GP engines. It is fitted with a magnetic insert ..
$10.00
Crankcase side cover exhaust stud
This stud is used to hold the exhaust bracket to the main engine casing. You need two per engine cas..
$2.00
Crankcase side cover gasket
Crankcase side gasket to fit all Series 1, 2 or 3 crankcase sides (except TV Series 1)...
$6.00
Crankcase side cover stud
This stud is the normal length crankcase side stud of which you need 14 for most crankcases...
$2.00
Crankcase side cover stud, extra long for exhaust tailpipe
RLC has had all the main studs remade for Lambretta engines, to our exact requirements. This is..
$2.25
Crankshaft connecting rod small end bushing, D/LD 16mm
Crankshaft connecting rod small end bushing, D/LD 16mm..
$7.00
Crankshaft drive side seal retaining plate
This is the remade drive side seal plate from Casa Lambretta. There are a lot of stories of drive ..
$20.00
Cylinder base gasket, large block: 200-250cc 0.5mm
This is a standard base gasket for all 200-225cc casings. It is approximately .5mm thick so can be..
$4.00
Cylinder base gasket, small block: 125-200cc 0.5mm
This is a standard base gasket for all 125-190cc casings. It is approximately .5mm thick so can be..
$4.00