Fasteners & Hardware
7mm rear hub lock washer bolt: Zinc
This 7mm fastener can specifically be used for securing the rear hub nut lock washer to an Italian o..
$3.00
7mm split lock washer: Zinc
7mm split lock washer. Zinc plated. Can be used in several places but is primarily used to secure th..
$0.45
BGM exhaust manifold hardware set
Complete hardware kit for any Lambretta Series 1-3 and DL/GP engine using a 4 stud pattern exhaust m..
$9.00
BGM intake manifold Allen bolt: M7 x 40mm Zinc
BGM intake manifold Allen bolt: M7 x 40mm Zinc, replaces long stud. ..
$1.60
Bodywork hardware kit: Series 3
You can take the guesswork out of rebuilding your series 3 or GP Lambretta by using our popular body..
$45.00
Bridge piece hardware kit: Series 1-3, GP/DL, Serveta
This kit includes: 2 m5 x 25 screws 2 m5 nuts 2 m5 wave washers ..
$3.00
Casa Lambretta complete Seat hardware kit: Series 3
One set is good for either front or rear single seat or for front pivot section of bench seat and re..
$20.00
Center stand feet pin: stainless
Used to secure the rubber center stand feet to the center stand. Stock ones rust and seize quite reg..
$1.50
Cone washer: 4mm solid
Cone washer (cup washer or finishing washer) for the headlight rim on Series 1-3 Li 125-150 Lambrett..
$1.00
Cone washer: 5mm solid
Cone washer (cup washer) used behind the legshield on Series 1-3 Lambretta. These are the solid mach..
$1.00
Cotter pin: fuel rod and rear brake cable clamp pivot pin
Cotter pin: fuel rod and rear brake cable clamp pivot pin...
$0.45
Crankshaft drive side seal retaining plate screw kit
If you've ever taken apart a Lambretta engine you will have struggled to undo the 4 screws that ho..
$4.00