Crankshaft & Piston
sdfsafsdfgsdfg
Crankshaft / Layshaft spacer shim: 1.5mm
This is a special crank shim made by MB Developments to fit on the crankshaft between the crank an..
$4.00
Crankshaft drive side seal retaining plate
This is the remade drive side seal plate from Casa Lambretta. There are a lot of stories of drive ..
$20.00
Crankshaft drive side seal retaining plate screw kit
If you've ever taken apart a Lambretta engine you will have struggled to undo the 4 screws that ho..
$4.00
Crankshaft oil seal for CasaCase engine case and CasaCooler: Viton 25-35-6
Crankshaft oil seal for CasaCase engine case and CasaCooler: Viton 25-35-6Two required!..
$12.00
Crankshaft: DL/GP taper 60 x 107mm
Our standard crankshafts are economically priced replacements for worn out or tired cranks. This is ..
$200.00
Crankshaft: DL/GP taper 60 x 110mm
This Italian GP crank is a good budget alternative to the range of BGM crankshafts. This quality roa..
$200.00
Drive side halite gasket
This is a drive plate halite gasket.It fits between the drive bearing and casing and the drive side ..
$4.00
Engine O ring kit
This handy kit contains all the O rings required when you are rebuilding a Series 1, 2 or 3 Lambrett..
$2.00
Engine oil seal set: Lambretta Series 1 LI
This handy kit contains the drive side oil seal, the magneto housing oil seal, the kick start shaft ..
$23.00
Engine oil seal set: Lambretta Series 1 TV
This handy kit contains all the seals required to rebuild a series 1 TV engine. Nitrile rubber.25x52..
$35.00
Engine oil seal set: Lambretta Series 2-3, DL/GP, Serveta
This handy kit contains the drive side oil seal, the two magneto housing oil seals, the kick start s..
$30.00
Flywheel nut washer: 4-pole and BGM GP flywheels
Correct flywheel washer for all 6v 4-pole and BGM GP flywheels. 23 mm across..
$2.00
Flywheel nut washer: 6-pole and BGM LI/TV/SX flywheels
Correct flywheel washer for all 6v 6-pole and BGM LI/TV/SX flywheels. 21.7 mm across..
$2.00
Flywheel nut: D/LD
Only suitable on a D/LDThings I've noticed about this thing, By Jon: I check every single one o..
$6.00
Flywheel nut: DL/GP
Only suitable on a DL/GP crankshaft - 23mmM12 X 1.00 LHThings I've noticed about this thing, B..
$6.00
Flywheel nut: Li/SX/TV 6-pole flywheels
Flywheel nut for Lambretta Li/SX/TV 6 pole flywheels. Measures 21mm.M12 X 1.00 LHThings I've noticed..
$6.00
Flywheel nut: Series 1-3, 4-pole flywheels
Flywheel nut suitable for early Series 1-2 4 pole flywheels. There are three different types of flyw..
$6.00
JB Fabrication Lambretta crank remover tool
JB Fabrication Lambretta crank remover tool, used to push your series 1-3 crank out of the bearing i..
$20.00
Large magneto housing/ flywheel oil seal: Nitrile 33-52-6
Large magneto/ flywheel oil seal: Nitrile 33-52-6..
$6.00