Fasteners & Hardware
This handy kit contains all the fasteners you would need for any series 2 headset...
$15.00
This handy kit contains all the generic fasteners you would need for any series 3 or GP headset...
$15.00
Hardware kit for securing the headset top to the headset bottom. Kit consisting of:
2 m5 x 40..
$2.00
Hardware kit for securing the headset top to the headset bottom. Kit consisting of:
2 m5 x 45s..
$2.00
For the front horn grill on all Series 3, DL/GP. This kit consists of:
2 m4 x 10 screws
..
$1.00
This kit includes:
2 m5 x 14 slotted oval screws2 m5 x 16 slotted oval screws4 m5 finish wash..
$7.00
This kit includes:
2 m5 x 10 panhead screws for the top
2 m6 x 18 Allen screws for the h..
$7.00
Inlet manifold bolt: M7 x 45mm Zinc, replaces long stud. ..
$0.75
Kick start lever bolt: M7 x 40mm Zinc..
$0.45
Kick start lever bolt: M8 x 40mm Zinc..
$0.45
Lambretta thicker 6mm nut used in various place on several different models from A to J50 Special.&n..
$0.75
Lambretta thicker 8mm nut used in various place on several different models from A to J50 Special.&n..
$1.10
Used for securing throttle and gear rods inside your headset - you need four per scooter. Also used ..
$0.45
Nord-Lock lock washer: M8For tubeless wheels.Sold each!..
$1.00
For installing the two outer front plastic rails on allSeries 3.
Consists of:
4 m5 nuts
..
$6.00
This kit includes are the hardware needed to secure the rear floorboard and plastic rails to all Ser..
$12.00
To install the rear floorboards and 4 rear plastic rails on all Series 3. Zinc plated.
Kit contai..
$12.00
Rubber bushing set for Serveta front dampersSold set of 4...
$36.00
Kit is for the rear saddle seat or rear bench seat latch. These plastic washers go between the seat ..
$2.00
Used to secure the Lambretta side panel handle. You need two per scooter. M6x12..
$0.45
Showing 81 to 100 of 106 (6 Pages)