Crankcase & Cylinder

This is a set of kick-start bushings (one inner and one outer) for any Series 1-3 and DL/GP type c..

$20.00

Magneto housing stud..

$2.00

PLC Course engine silentblock rubber inserts only, set: 175-200 type, green = soft..

$45.00

PLC Course engine silentblock rubber inserts only, set: 175-200 type, orange = hard..

$45.00

PLC Course engine silentblock set (mount): 175-200 type, green = soft..

$78.00

PLC Course engine silentblock set (mount): 175-200 type, orange = hard..

$78.00

This item screws into your engine casing and your brake shoes pivot on them. You need two per casing..

$6.00

This pin fits into your engine casing and your brake shoes fit onto it. It suits Li, SX. TV type bra..

$6.00

This shim fits between the plate and the casing. It acts as a gasket and shim...

$2.00

This plate holds the rear hub bearing in place...

$4.00

This 6mm x 21mm stud is designed to fit on the casing where the rear hub bearing sits and holds on t..

$2.00

This shaft fits into the engine casing and the rear shock mounts to it. Sometimes the thread gets da..

$14.00

This small rubber buffer fits into the chaincase side to stop the kick-start pedal when it springs b..

$3.00