Search
Products meeting the search criteria
"L" tube for throttle cable at handlebar: 150D, LUI
"L" tube for throttle cable at handlebar: 150 D, LUI..
$16.00
Bench seat cover: Red
Bench seat cover in red. As found on Series 3 SX200 Lambretta. Highest quality seat cover available...
$140.00
BGM 12v replacement stator wiring Lambretta
Complete replacement wiring for any BGM or SIL type 12v stator. Comes with grey and black sleeving a..
$15.00
BGM air filter box system: late series 2, 3, DL/GP, early Serveta
This is the bgm PRO air filter box for your Lambretta Series 1-3. The box is based on a SIL airfi..
$150.00
BGM CDI/Ignition coil (blue)
This is a remade electronic ignition coil as used in 12v type Lambretta electronic ignitions. We use..
$30.00
BGM front brake cable top hat
This is a remade front brake top hat from BGM. It has the notch in it to allow for removing the fron..
$1.40
BGM gear/clutch cable trunnion: long, oversized
BGM high quality cable trunnion done in brass oversized for worn gear selector pivot. This is the lo..
$4.75
BGM gear/clutch cable trunnion: short, oversized
BGM high quality cable trunnion done in brass oversized for worn gear selector pivot. This is the sh..
$4.75
BGM gearbox shim: 1.8mm
This is a gear shim. It is used to shim up the gearbox. The ideal clearance, measured with a feeler ..
$8.50
BGM high flow air filter: late series 2, 3, DL/GP, early Serveta
The bgm PRO Lambretta air filter is the ultimate replacement for all standardish Lambretta paper fil..
$26.00
BGM high flow air filter: Series 1, early series 2
The bgm PRO Lambretta air filter is the ultimate replacement for all standardish Lambretta paper fil..
$26.00
BGM PRO Superstrong complete clutch for Lambretta: 47 tooth
BGM PRO Superstrong - the originalThe Superstrong clutch combines extreme durability, absolute relia..
$550.00
BGM rear brake cable top hat
This is a remade rear brake top hat from BGM. You need two per scooter...
$3.00
BGM remote air filter: 48mm
BGM stainless steel air filter that fits all Dellorto PH, Keihin PWK 24-30mm (and copies) and some s..
$20.00
Casa Lambretta control cable set: LD MK3
Cable set, inner and outers, greyCables identification by length in mm (approx): ..
$45.00
CasaCooler standard magneto housing kit: blue
This is the new ‘CasaCooler’ magneto flange kit! It comes 101% complete and is plug n’ play for any ..
$580.00
Casatronic Ducati 12v electronic ignition kit for GP crank, ROAD tune, standard weight flywheel
Complete Casatronic Ducati 'STANDARD' 12V electronic ignition kit for all Lambre..
$530.00
Center stand reinforcement plates
It is commonly found that Lambrettas are wobbly on the stand and end up sitting lower and lower on t..
$5.00
Crankcase side cover exhaust stud
This stud is used to hold the exhaust bracket to the main engine casing. You need two per engine cas..
$2.00