MB Rubber carb mount: 22-26mm carbs with 30mm spigot connection

This Mark Broadhurst redesigned, improved and strengthened Viton carb mounting rubber which suits all Dellorto 22 - 26mm PHBL carbs.

It also fits the Mikuni 24mm TMX.

It comes marked with MB.

Fits 30mm spigot outside diameter, lipped one end for the carb side straight on the other.

The rubber measures 36mm in length.

Can come in Black or Brown depending on stock at the time.
 

TIPS:

1. Make sure both inlet manifold and carb are clean and dry before fitting
2. Always use the wide type Jubilee clips
3. Do not over tighten the clips
4. Always carry a spare
5. Regularly lightly twist the carb to check for splits
6. Support the base of the carb against the cowl to hold the weight of the carb