Casa Performance CNC SS/SSR/SST intake manifold: 28-30mm

THE NEW CNC INLET MANIFOLD FROM CASA PERFORMANCE FOR 28mm - 30mm CARBS! 

Working with specialists in this field we have completely designed this new inlet manifold, to gain better internal flow, and also to lower it slightly to give better frame clearance. The results have been superb to say the least. Power is also up slightly by about 0.8bhp at the rear wheel when compared to the cast manifold X57b.

This new manifold is for 28-30mm carbs. We’d seen that when customers wanted to fit smaller 28-30mm carbs to their ‘SST265 Touring’ motors, the float bowl was fowling against the actual engine casing and people were subsequently adding thick spacers between the carb rubber and inlet manifold to alleviate the issue. This new CNC manufactured manifold resolves that and the carb rubber can be mounted directly to the manifold. It comes with an integral gas-flow ‘stuffer’ on the underside and is supplied complete with fixing screws and gasket.

This is a plug ‘n’ play inlet kit suitable for all SS200, SS225, SS250, SSR250, SSR265 Scuderia engines & kits.

The manifold kit will includes:
1  x  CNC manifold the manifold
1  x  inlet gasket
4  x  fixing screws

As an optional extra you can add a Casa Performance inlet rubber!