Search
Products meeting the search criteria
BGM crankcase side cover hardware set
Complete hardware kit for all Lambretta Series 1-3 and DL/GP crankcase sides. Kit includes all studs..
$26.00
BGM exhaust manifold hardware set
Complete hardware kit for any Lambretta Series 1-3 and DL/GP engine using a 4 stud pattern exhaust m..
$9.00
BGM superstrong clutch springs, hard, sold in sets of 5
These are the bgm PRO Lambretta Superstrong clutch springs from Germany. These springs are especiall..
$14.00
Bodywork hardware kit: Series 2
You can take the guesswork out of rebuilding your series 2 Lambretta by using our popular bodywork h..
$45.00
Bodywork hardware kit: Series 3
You can take the guesswork out of rebuilding your series 3 or GP Lambretta by using our popular body..
$45.00
Bridge piece hardware kit: Series 1-3, GP/DL, Serveta
This kit includes: 2 m5 x 25 screws 2 m5 nuts 2 m5 wave washers ..
$3.00
Casa Lambretta complete Seat hardware kit: Series 3
One set is good for either front or rear single seat or for front pivot section of bench seat and re..
$20.00
Casa Performance CasaCase hardware set
Complete set of high quality hardware + shims + fasteners + studs needed to complete partially assem..
$85.00
Casa Performance crankcase side cover hardware set: Zinc
Complete hardware kit for all Lambretta Series 1-3 and DL/GP crankcase sides. Kit includes all studs..
$42.00
End cap hardware kit: Series 3
Hardware that goes through all the endcaps of a Series 3. Kit contains: 6 m4 x 20 screws ..
$10.00
Engine circlip kit
This handy bagged kit contains the correct circlips you need to overhaul a Lambretta engine. It does..
$12.00
Floorboard runner strips kit (7 pieces w/hardware): J range
Floorboard runner strips kit (7 pieces w/hardware): J range..
$55.00
Flywheel and cylinder shroud hardware kit: Series 1-3
To install both the cylinder and flywheel/fan shroud on Series 1-3, DL/GP. Consists of: 7 m5 ..
$5.00
Front floor rails hardware kit: Series 3
For installing the 4 front alloy channels on Series 3 and DL. Consists of: 6 m4 x 10 screws..
$12.00
Front mudguard hardware kit: Series 3
This kit includes: 2 m5 x 20 screws for the bottom (under aluminum channel) 2 m5 nuts for ab..
$5.00
Handlebar lever pivot screw: D/LD
Handlebar lever hardware (bolt, nut, and washer) for D-LD version II-III. Made in Italy...
$8.00
Handlebar light switch screws: Series 1-3, GP/DL, Serveta
Kit for securing the light switch to the handlebar. Consists of: 2 m3 x 25 screws ..
$2.00
Headlight rim hardware kit: Series 1, Series 2 Li/TV, Series 3 Li
Headlight rim hardware kit: Series 1, Series 2 Li/TV, Series 3 Li. Kit consisting of: 4 m4 x 1..
$2.00
Headlight rim hardware kit: Series 3 LiS/TV/SX
Kit for securing the headlight rim on all Series 3 LiS, TV and SX models. Kit consists of: 4 ..
$1.00