Search
Products meeting the search criteria
Cable housing ferrule crimping tool
Cable housing ferrule crimping tool, The Alligator, for crimping the little metal end onto you cable..
$50.00
Cable housing protection sleeve (black)
This item helps protect the control cable outers as they pass through the frame and sit next to the ..
$2.00
Cable housing protection sleeve (grey)
This item helps protect the control cable outers as they pass through the frame and sit next to..
$2.00
Cable inner and housing cutting tool
Cable inner and housing cutting tool.Only for cutting cable inners and housing, DO NOT use to cut sc..
$50.00
CasaCooler standard magneto housing kit: gold
This is the new ‘CasaCooler’ magneto flange kit! It comes 101% complete and is plug n’ play for any ..
$580.00
CasaCooler standard magneto housing kit: orange
This is the new ‘CasaCooler’ magneto flange kit! It comes 101% complete and is plug n’ play for any ..
$580.00
CasaCooler standard magneto housing kit: red
This is the new ‘CasaCooler’ magneto flange kit! It comes 101% complete and is plug n’ play for any ..
$580.00
Control cable housings/outers made to custom length
I can make custom length cables for you in black and grey colors. I use the same cable housing that ..
$10.00
Handlebar 4 speed gear selector: Series 1 Li, 2 LI/TV
Handle bar support for series 1 Li, 2 LI/TV Lambretta. ..
$70.00
Handlebar light switch housing screw
Used to secure the Lambretta light switch housing to the headset. You need two per scooter. M6x12..
$0.45
Handlebar light switch housing: Series 1-2 LI
Another mentally hard to find part that we have just had remade are these handlebar switch / front b..
$58.00
Handlebar light switch/lever housing throttle side: D/LD
Handlebar light switch/lever housing throttle side: D/LD..
$80.00
Magneto housing sealing plate kit
Magneto housing sealing plate for any Series 1-3 engine. Includes two backing plates. Gasket, rubber..
$20.00
Magneto housing spacer, Li/SX/TV
These fit in all magneto housings when using the standard Li, SX, TV type flywheel bearing. It fits ..
$4.00
MB End plate and magneto housing extractors
Another tool copied from the original Innocenti version with a slight MB Developments improvement...
$25.00
Rubber tail light housing gasket: GD/DL, Serveta, black
Rear light gasket for late DL/GP Lambretta in black. Made in Italy...
$10.00
Rubber tail light housing gasket: Series 1-2 (early)
Tail light housing gasket for all Series 1 and Series 2 up to mid 1960. This fits the smaller tail l..
$10.00